Let’s say you want to wait a certain amount of time before step in your cycle is activated.
In this scenario, I’m pulling a value from a spreadsheet and sending it via email. If I want to delay this email by a couple of hours for example, I can do this with a delay step.
All you need to do to set this up is define the number of seconds, minutes, hours, until you wish to step to act.
If you want to wait until a specific date that’s already defined in your data, you can use a wait until step.
Simply map the required value in the step, and if necessary, set an offset of for example 30 minutes before or an hour after the defined value.
Bear in mind that the date must be within 31 days or the cycle not complete.